Hello, I tested the Scanalogic with Atmega8 at 8 MHz (scanalogic_8MHz.hex) .
I tested the lines of a working SPI-bus, the TxD line of a UART and an 10kHz rectange
from a function-generator.
At first in the PC-Software were written some text lines, ending all with OK or Done.
The last line was: downloading samples and many bars.
But that was all. No samples were to be seen.
The LED was on. On the RxD/TxD-lines were some transmissions for a short time.
And then nothing more. What could be the failure?
Thanks for help